This is the first in a series of articles on the arrangements of the various models of alarm charges , will call attention to these schemes should be used by people with technical skills for this purpose and will not invalidate the consultation of the arrangements specific to each car model.
Installation drawings Globe 3100
The arrangement has all the generic links to the Globe 3193 Series models (not self powered siren) and 3195 (self powered). Connections in each vehicle model with the specific locations and wire colors shown here are not original.
The call of the siren is the only difference in the arrangement for the 3193 model.
All connections are important, not only for the proper functioning of alarm and consequent protection of the vehicle but also for access to the various functions of programmable alarms Cobra, not to link switch bonnet or even links to invalidate the door contact table entry advanced features or to customize the Pin Code .
Although it is a commonplace not be overstressed the fact that all connections must be soldered, the use of quick connectors, although increasing the speed of assembly, can cause long-term failures in the normal functioning of mass alarme.Todas links should be made to the chassis of the car in places provided for this purpose, always look for existing mass points and avoid the use of self-drilling screws that over time tend to loosen.
I hope this scheme will help in the assembly or diagnosis of a malfunction in the alarm series Globe 3100.
Read also these articles:
 |  |
 |  |
 |  |
39 Comments on "Arrangement Globe 3100-Serie"
Hi from google Google-TCW
Correction, the main 16-pin connector
Technical Staff Good afternoon
I have an alarm that does not know the model, but I have descriptions:
3 connectors: de16 a pin, a 3-pin and one 2-pin.
On board there are some numbers 1436-12, 2104; Ti-18739B, and only one relay output.
I need to install in another vehicle, but do not have the manual (wiring diagram), you can send a copy by e-mail
Thanks
Lemongrass
Good afternoon,
I do not think the alarm is referring to Cobra and therefore have difficulty in getting any scheme.
Try to know the make and model.
Cumps
Good evening.
Does the scheme can find an assembly of 3995?
I have this model installed in a Golf IV and I'm having some problems.
The car failed to lock and unlock the doors and up the glasses with the command of the alarm.
I've tried programming but did not work. I assume you have your installation fails, because I have cut two wires with no apparent connection module confort of the car.
Thanks
Good night
The wires of the central locking on the VW Golf IV are yellow / blue and green / red are in the driver's door.
To trigger the timer in windows just 24sec closing time.
Cumps
Good morning.
Thanks in advance for your attention.
And the wireless alarm? Do you know what?
Greetings
Good night
The violet and orange open closed.
Good night ...
I bought an alarm for use in a 3868 Cobra Golf IV but the manual is in German and need an arrangement for connecting the module comfort of this car. Can you help please?
More your questions: I can connect the brown wire I will climb the glass when you activate the alarm without timer? That is always sending negative?
Turning the comfortable layout by turning the key in the door in the cannon will disable the alarm as with the OEM alarm? It is not possible to make only with the disable command?
Thank you ..
Good night
You only need the comfort of the links?
As the other, but power can not be the same, so if you is always in charge, imagine what happens.
You must use brown wire connected to the module 1055 in order to turn off after closing the windows.
The output is negative and the wire is yellow / blue glasses to climb.
If I remember correctly only with the command off.
Cumps
First of all thanks for your kindness and short answer ...
His work in this blog is something great, congratulations ...
Actually for now I think I will leave the closing of part of glazing ..
The rest of the links I think I get there easily, I needed to know was that the cables connecting the alarm system comfortable for activation of the alarm.
Your VW Golf has original remote controls?
yes, you .. And alarm but also do not have volumetric protection, so perimetry
The alarm also has commands?
If the alarm has commands is not 3868, probably 3198 or 3998 if it is compact.
The arrangement is different.
Confirm the type of alarm.
The alarm has no commands, it's 3868
Most spoke of the original car alarm .. As there are volumetric protection will be installed to complement the 3868 charges .. Thank you.
Ok, I finally understand.
Watch your mail box.
Even if it was needed.
Thank you for your availability ..
Greetings
I have a good alarm cobra G198 when I want to set the beep but when I can not close the capon is in memory of the alarm which can be thankful to your help thanks
good night
I got a Next and honda concert and have it install a snake alarm 3995. But when I installed the alarm they put me n the engine block to do because they said the car by not having control unit did not.
I wonder if I can do this and how
cumps
It is often not made the cut in vehicles with the engine immobilizer serie.No however can always be done using the two green wires to stop the gas pump, starter motor or ignition.
Good. I have a Mitsubishi charisma 99 tem1 alarm that snake that I think is the source. Tou good problems because the alarm goes off frequently for no apparent reason. I can not know why. I thank any help. Thank you.
In most cases the origin is the bonnet switch, you can try turning it off and see if stopped playing.
Good afternoon.
Now the my congratulations on this page.
I have a Cobra alarm fitted in my Ford Fiesta 2006 by the dealer at the time of purchasing the car.
The 3195 is the main module, the module is the glasses and the siren is 2980 3310.
My question is: with the alarm on if I run the ignition key the car works even with the alarm ringing. Will be some programming problem or the alarm can be incorrectly attached?
What would you advise me!
Thanks
The reason this happens is because it was not made the cut ignition.
good afternoon
I bought a Mitsubishi ASX with keyless locking system (qd close I move away from the vehicle and opens as I approach and press the door handle) told me that the brand can not put the alarm with the function of closing the windows. It is possible to give me your opinion and if it is possible to have this function?
Thanks
What year of car and number of windows?
I have a good night alarm cobra g365 someone I can arrange the required programming scheme.
What is the program you need?
I have a good alarm like this Globe 3100
and found that the colors do not have the central locking wires can give me the layout of the central feicho
What is the car where you want to make connections?
good, needed to know how to see the model I have installed alarm cobra, I bought a 1990 car that has a cobra alarm, at least so says the device, which is a 2T, square buttons with yellow and green, but the alarm is not working, who sold me the car so I said it was a green wire cut and chant because I do not know if you miss any part of the alarm. already changed the battery but I think that the alarm does not work. thanks
Good! Recently I lost a few keys to my car, along with the command of the alarm. I wonder if, somehow, there is the possibility of barring access to the vehicle lost through this command. Thanks in advance!
I have a good alarm like this Globe 3100
and found that the colors do not have the central locking wires can give me the layout of the central feicho
The car is a OPEL ASTRA 1994.
The orange wire and violet are the opening and closing and purple / white and orange / white are connected to the earth.
Just make the process of learning new commands, delete the old record.
Hello, I already have an alarm, he has a 7 years of use, has always worked well, but has had problems such as fire alone, and control only works up close, if I decide to change the alarm n must replace all the wiring (the locks and sensors), correct? It would be simpler? Or they could fix it? Again, it just shows these two defects.
Thank you and congratulations on your site!
What brand of alarm?
To activate you need to connect with a key on the siren.
I would like some help to get the wiring diagram Alarm Cobra 4615 Can / PLIP, because I need to install the alarm in a Smart f2 2009.
Thanks in advance for your help.
Graciously
Silva1980
The scheme comes with alarme.Onde bought?
Comments