Sometimes we want to leave the car windows slightly open, especially in summer, or when we want to make an animal or someone inside the vehicle while the alarm on, what happens is that the sensors will detect volumetric and in turn trigger the siren.
If you have not installed a module you can climb glass temporarily disable the alarm sensors.
How to disable the volumetric sensors
Connect the alarm usually via the "A" command .
Within 40 seconds press the "B" command.
As confirmation of the deactivation of the alarm volumetric sensors send a signal through the more buzzer.Todos other protections alarm remains active unless the volumetric sensors.
You can just leave the windows slightly open your vehicle or someone inside the car without the alarm starts to ring.
The next time you turn the alarm sensors will turn on automatically.
Was this tip on charges alarms helpful?
Read also these articles:
 |  |
 |  |
 |  |
5 Responses to "How to disable the volumetric sensors"
Good!
Here we inform you how to temporarily disable the volumetric sensors ..
Since it is a convertible roof and canvas, the fact that the volumetric sensors can give them false alarm in the event of a windstorm that can shake the hood?
My question is, you can install the alarm without applying the volumetric sensors?
John Duarte
It is more likely to trigger the alarm, but you can always disable the sensors, the manual is how.
Good!
I wonder if this table programming
http://alarmescobra.com/2009/02/programar-funcoes-base-e-avancadas/
also serves to alarm the G198.
If so, there is a function by means that do disable the volumetric sensors?
John Duarte
No, this table is for the previous model.
Admin @ January 3rd 2011 at 6:29 pm
No, this table is for the previous model.
And what the table for model G198?
John Duarte
Comments